×

Model RELM

Round Electric Lift Magnets

Product Features
  • For use on flat material only
  • 115 volts AC required
  • On, off, and release functions are recessed to protect against accidental operation
  • Easy to use
  • Complies with ASME standards

Note:

RELMs are not intended to be used as scrap handling magnets. Wall plug is not included. Twist lock style plug is recommended.

  • *RELM Holding Values are stated at 50% of the actual value for a 2 to 1 design factor.

Support & Documents

Warnings

WARNING

All capacities are based on lifting clean, smooth, flat low-carbon steel plate with the full area of the magnet’s lifting surface in contact with the load. Derating is required for plates or other loads with rust or scale. Do not use on material thinner than 1/4”.

Note: When lifting 4’ x 8’ sheets or any sheets over 4’ x 8’, use 2 or more magnets on a spreader bar to prevent sheet flexing, sagging, or peel-off. Material less than 3/8” thick is susceptible to magnet bleed through, resulting in two sheets lifted at once.

Model Number
*Holding Value  (lbs.)
Voltage (VAC) 
Watts 
Amps 
Magnet Dia. A (in) 
Magnet Height B  (in.)
Overall Height C  (in.)
Bail Height  (in.)
Bail W  (in.)
Weight  (lbs.)
In Stock
Price
RELM06
1000
120
85
0.8
6
3
6
1.31
1.31
30
 
RELM08
2000
120
130
1.1
8
4.11
7.38
1.31
1.31
58
 
RELM12
4500
120
200
2
12
5.25
9.25
1.75
1.75
152
 
RELM16
8000
120
310
3
16
6.75
12.75
6
3.5
365
 
RELM20
12000
120
570
5
20
7.5
14
7
4
545
 

Due to unpredictable fluctuations in the supply chain, pricing is subject to change without notice. Call 800-628-4263 for updated information.